Hi
I have problems with the RPM counter from Koso, when adjusted to 2c-1p it counts way to much, when adjusted to 2c-2p it is better but very unaccurate, the pickup is connected to the red rpm wire output from the HPI ??
Can anyone help ??
Thanks
Michael
Er zijn 8 resultaten gevonden
- 04 mei 2020, 17:36
- Forum: Technisch forum - Technical forum
- Onderwerp: KOSO RPM error with HPI
- Reacties: 0
- Weergaves: 1887
- 02 nov 2009, 18:50
- Forum: Technisch forum - Technical forum
- Onderwerp: PISTON MARKINGS
- Reacties: 2
- Weergaves: 1433
- 02 nov 2009, 11:52
- Forum: Technisch forum - Technical forum
- Onderwerp: PISTON MARKINGS
- Reacties: 2
- Weergaves: 1433
PISTON MARKINGS
Is there a thread with piston markings so one can find out who made the specific piston and what quality range it belongs to? If not I propose you take a photo of your piston with its different markings and describe the following: Markings: Fabricate: Intended use: (RS, GT, Race, etc.) Quality: Mich...
- 14 okt 2009, 18:25
- Forum: Technisch forum - Technical forum
- Onderwerp: Krankshaft problem
- Reacties: 8
- Weergaves: 1557
- 13 okt 2009, 21:18
- Forum: Technisch forum - Technical forum
- Onderwerp: Krankshaft problem
- Reacties: 8
- Weergaves: 1557
- 13 okt 2009, 20:47
- Forum: Technisch forum - Technical forum
- Onderwerp: Krankshaft problem
- Reacties: 8
- Weergaves: 1557
- 13 okt 2009, 19:26
- Forum: Technisch forum - Technical forum
- Onderwerp: Krankshaft problem
- Reacties: 8
- Weergaves: 1557
Krankshaft problem
Hi All I have a problem with my 5 gear RS motor from 1968. I have replaced all bearrings and the krankshaft, I had big problems replacing the krankshaft bearrings and had to heat the parts to 250 degree C before I could get the the parts out of the engine housing. Replacing was easier but now the ne...
- 04 sep 2009, 23:57
- Forum: Technisch forum - Technical forum
- Onderwerp: 1968 Rennkit piston dimention
- Reacties: 0
- Weergaves: 1126
1968 Rennkit piston dimention
Hi All I need the excats dimention of the 1968 rennkit 9.5PK piston. I am going to have a new nikasil made inside my 15 43.91 cylinder and I dont have the original piston so the machineshop need all the dimention on the original piston to make a new one, so can anyone help who have the original pist...