Kreidler RMC S transfers

[fugledal]

Hello,

I have bought some new RMC S transfers from Kreidleroriginal.com, but I find them hard to fasten properly. I'm wondering if I do something wrong. It seems like the glue is not fasten to the paint properly. It was the same with the "Elektronik" transfer also.

Anyone on this forum who has some experience with this? Do they need to be wet whit water or something like this?

[Enzo-tvdzijden]

Hello,

I have bought some new RMC S transfers from Kreidleroriginal.com, but I find them hard to fasten properly. I'm wondering if I do something wrong. It seems like the glue is not fasten to the paint properly. It was the same with the "Elektronik" transfer also.

Anyone on this forum who has some experience with this? Do they need to be wet whit water or something like this?

No, make al little warm with heating gun (both included where to come)
And rub with a round metal frome the backing. Very easy !!!!

Look the pictures in this topic

viewtopic.php?f=23&t=45338&hilit=Remon&start=50



Enzo

[fugledal]

I tried this also, but is does not stick to the paint. It looks like the glue is not there. Is it possible to add any kind of glue, and try with this? When touching the back side of the transfer, I can not feel any glue with my finger at all.

[Jan]

I think you have a pitty and bought some old dried out stickers, named crab
Return the stickers to sender and ask new stickers for free.
Let them know that you informed the Kreidler forum, maybe this helps to get them free.

[Enzo-tvdzijden]

I think you have a pitty and bought some old dried out stickers, named crab
Return the stickers to sender and ask new stickers for free.
Let them know that you informed the Kreidler forum, maybe this helps to get them free.

Less info Jan. No reaction from anybody who fitted the Elektronik transfer

was is the original Bentlage transfer

Enzo

[fugledal]

Thank you for yours feedback.
I managed to do both Elektronik transfer on both sides, that was OK, but a little bit problem with one of the Elektronik transfer.
I also managed one RMC-S transfer on one side. But the other one, then the S was stuck to the bottom cover paper (for glue), and was damaged when I tried to remove the paper. I then got a new S free of charge, and this is the one I have problem with now.

The Elektronik transfer seems to be in one unit, while the RMC-S is in individual letters.
I will ask for a new S, and try again.

Frank

[Enzo-tvdzijden]

It is a Special techique what not eveybody knows and can. There is a lot of experience needed

[fugledal]

And I'm one who needs to learn this

When using hot air gun, shall I then heat the metal cover first, then fasten the transfer with some tape, then heat the transfer a bit with hot air also?
And then use a rounded metal tool to "rubber" all over the transfer ?

I did a similar thing with the other transfers, but no metal tool, only working with my finger over the transfer.

But this last "S" I received is something different, looks like something wrong with the glue.

Frank

[Caspar]

First heat the metal , than the sticker.
Put the sticker on the right place and rub it off with a pencil.
Use a soft black or grey pencil . That shows you where you rubbed already.

[tonnie de groot]

dag heren,


vorige week een complete stickerset van een rmc-weltmeister besteld bij kreidlerparts.
de hamsterbak stickers met rmc-s plakken inderdaad niet meer.
wat je ook probeerd en doet, ik heb coen een mail gestuurd.
tot op heden niets gehoord.
stickers zijn wel origineel.....................maar zijn te oud om te plakken.